I. Product Introduction:
The one-component strong nail-free adhesive based on modified polyether polymer has excellent bonding performance for materials such as metal, ceramics, stone, wood, glass, and some ABS plastics.
Ii. Product Features
Environmentally friendly with low VOC, no solvent evaporation, and non-toxic.
High initial adhesive strength, rapid positioning, and excellent extrudability;
Strong adhesive force and strong shock resistance;
It has good water resistance and can be operated underwater.
The surface can be coated and has strong aging resistance.
Iii. Product Application
It is used for bonding, fixing and load-bearing of materials such as home decoration hardware hangers, floor skirting boards, home decoration stones, advertising letters, ceramics, glass and wood.
Iv. Product Performance
Chemical Basis: MS polymers
Colour: White
Curing mechanism: Moisture curing
Drooping degree: 0
Surface drying time: approximately 20 minutes
Solid content: 99%
Specific gravity: 1.69
Hardness: Approximately Shore A 55
Viscosity: Approximately 1530 Pa.s
Curing speed: 4mm/24h
Tensile shear strength/standard test conditions 24 hours: 2.75mpa
Tensile shear strength/standard test conditions 168 hours: 3.22mpa
V. Instructions for Use
1) Surface treatment
The bonding surface should be clean, free of grease, oil and dust. Applying a primer to surfaces that are difficult to bond (such as easily loose stone surfaces, etc.) can enhance the bonding effect.
2) Construction
Aluminum-plastic pipe packaging: Construction can be carried out by piercing the head of the aluminum pipe with a screw cap.
Hard tube packaging: Just cut open the tube mouth.
When applying adhesive during construction, either a cross-shaped or strip-type application is adopted. The correct amount of adhesive to be applied should be selected based on the different base materials.
3) Curing time and load-bearing capacity
Load-bearing should be resumed 48 hours after construction (in winter or dry weather, the delay should be appropriately extended to 72 hours)
4) Surface finishing (when necessary)
Colored paint can be applied before and after surface drying.
Vi. Packaging
Aluminum-plastic pipe 6g, aluminum-plastic pipe 12g, aluminum-plastic pipe 60g, hard pipe 300ml, flexible pipe 590ml, large drum 200L
Vii. Storage Period
Shelf life (Store in a sealed container below 25℃) : 12 months.
Viii. Safety Operation Data Technical Data Sheet
Product safety data is not included here. Before use, please pay attention to reading the product information, product safety data and packaging labels to ensure safe use. Product safety information can be obtained from Uli and its distributors.
Ix. Quality Guarantee - Please read it carefully
We guarantee that the product performance and usage information contained here are accurate and reliable. However, before using it, you should still test its performance, safe usage and other aspects. The suggestions for the application should not be regarded as applicable in all circumstances. Unless ULI provides a written proof of suitability for a specific need, ULI only guarantees the specifications listed in the product sales manual and does not guarantee other uses. Youli's sole responsibility lies in providing refunds or exchanges when the products fail to meet the listed requirements. Youli explicitly states that it will not be held responsible for any accidents.
